Vokera Pinnacle System fault E010
Maximum number of ignition attempts
Gas boilerWhat it means
Fault indicating the boiler has exceeded the maximum number of attempts to ignite the burner.
Likely causes
- Ignition failure
- Gas supply issue
- Ignition electrode fault
Where to start
- Check gas supply
- Check ignition electrode condition and gap
- Check ignition sequence
The full answer, free
- How to put it right, step by step
- The manual page for this fault (page 4), right under the answer
Safety: Isolate gas and power before you open the case. If you have been into the gas side, do a tightness test, and a combustion and flue check before you hand back. Gas Safe (UK) or RGI (Ireland) work only.
From the Vokera manual for the Pinnacle System. Check the model on the data plate before you order parts.
Other Vokera Pinnacle System fault codes
- COMAppliance PCB communication lost
- E011Parasitic flame
- E020Limit thermostat
- E021Gas valve control malfunction
- E033Rotor fan failure damaged
- E034Chimney obstruction in preventilation
- E035Blockage obstruction flue gas low power
- E036Blockage obstruction flue gas high power
- E040Low water pressure (definitive fault/lockout)
- E041Low water pressure (temporary fault)
- E050Smoke obstruction error low power
- E051Smoke obstruction error high power
- E055No card fan communication
- E075Valve opening limit reached
- E077Absence of communication with low temperature thermostat
- E091Primary heat-exchanger cleaning fault
- E099Reset attempts exhausted
- FILLow water pressure (warning signal)