Vokera Pinnacle System fault COM
Appliance PCB communication lost
Gas boilerWhat it means
Signal indicating communication with the appliance PCB has been lost for more than 30 seconds. The boiler continues to operate but with no display or keys.
Likely causes
- PCB communication failure exceeding 30 seconds
- Incorrect connectivity configuration leading to communication failure
Where to start
- Use conductors no larger than 0.5mm² for CE4 MODBUS connections
- Select appropriate option: Wi-Fi key activate, Ignore wifi key / Modbus remote control, or OT config Activate function
The full answer, free
- The readings and component tests from the manual
- How to put it right, step by step
- The manual page for this fault (page 7), right under the answer
Safety: Isolate gas and power before you open the case. If you have been into the gas side, do a tightness test, and a combustion and flue check before you hand back. Gas Safe (UK) or RGI (Ireland) work only.
From the Vokera manual for the Pinnacle System. Check the model on the data plate before you order parts.
Other Vokera Pinnacle System fault codes
- E010Maximum number of ignition attempts
- E011Parasitic flame
- E020Limit thermostat
- E021Gas valve control malfunction
- E033Rotor fan failure damaged
- E034Chimney obstruction in preventilation
- E035Blockage obstruction flue gas low power
- E036Blockage obstruction flue gas high power
- E040Low water pressure (definitive fault/lockout)
- E041Low water pressure (temporary fault)
- E050Smoke obstruction error low power
- E051Smoke obstruction error high power
- E055No card fan communication
- E075Valve opening limit reached
- E077Absence of communication with low temperature thermostat
- E091Primary heat-exchanger cleaning fault
- E099Reset attempts exhausted
- FILLow water pressure (warning signal)