Vokera Pinnacle Combi fault E050
Smoke obstruction error low power
Gas boilerWhat it means
Transitory error indicating smoke/flue obstruction detected during low power operation.
Likely causes
- Flue obstruction
- Incomplete combustion at low power
- Flue components not correctly assembled, fixed or supported
- Flue or flue terminal obstructed
- Leaking seals around appliance burner, internal flue seals, door and case seals
- Inhibitor depletion over time requiring annual concentration check
Where to start
- Check flue for obstruction
- Check combustion analysis
- Navigate to Configuration menu
The full answer, free
- 41 more checks in order
- The readings and component tests from the manual
- How to put it right, step by step
- The manual page for this fault (page 8), right under the answer
Safety: Isolate gas and power before you open the case. If you have been into the gas side, do a tightness test, and a combustion and flue check before you hand back. Gas Safe (UK) or RGI (Ireland) work only.
From the Vokera manual for the Pinnacle Combi. Check the model on the data plate before you order parts.
Other Vokera Pinnacle Combi fault codes
- COMAppliance PCB communication lost
- E010Maximum number of ignition attempts
- E011Parasitic flame
- E034Chimney obstruction in preventilation
- E035Blockage obstruction flue gas low power
- E036Blockage obstruction flue gas high power
- E041Low water pressure (temporary fault)
- E042Water transducer - LWCO error
- E051Smoke obstruction error high power
- E055No card fan communication
- E056No communication microprocessor card
- E070CH probe error
- E071Heating temperature over limit
- E072Delta T return out of limit
- E077Absence of communication with low temperature thermostat
- E080Return probe error
- E081Return temperature over limit
- E082Warning delta temperature
- E090Exhaust probe error
- E091Primary heat-exchanger cleaning fault
- E095Calibration failed
- E096Lambda over limit
- E099Reset attempts exhausted